Replacing a PDZG-E

Due to security restrictions, the PDZG-E’s Zigbee encryption details are not locally accessible from SB. To perform a drop-in replacement, this information must be loaded from your Dynalite Cloud save.

  1. Save the latest version of your jobfile to Dynalite Cloud.

  2. Connect the new PDZG-E to the same LAN as the PDDEG-S/PDTS and ensure that it is powered on.
    The PDZG-E takes approximately 1-2 minutes to boot up and connect to the network.

  3. In System view, click sb icon insert device from network Search Devices (Ctrl+L).

  4. In the Search Devices window, click sb icon discover network Discover Network > Discover Devices over Ethernet. All discovered devices are listed.

    sb discover over ethernet

  5. Click and drag the newly discovered PDZG-E from the Search Devices window onto the old PDZG-E in the System View device tree.

  6. Close the Search Devices window.

  7. Select the PDZG-E, open the Connection Settings tab and click the Connect button.

  8. Click sb icon save to device Save to Device (F12). Select Resave all device date and sb icon checkbox tick Save Zigbee Network Settings, then click OK.

    sb save to device pdzg e zigbee

PDZG-E Hardware Reset Procedure

  1. Press and hold the service switch button for 30+ seconds, then release.

    dyn pdzg e service switch

  2. The middle LED blinks for approximately 30 seconds.

  3. Approximately 5 seconds later all LEDs briefly illuminate.

  4. The left LED illuminates briefly, after which the device resumes normal operation (Left LED off, Middle LED blinking, right LED permanently on).

  5. To resave the existing configuration to the PDZG-E, follow the replacement procedure above.