Property Editors
SB has the following editors for configuring the DDNG232:
|
Displayed fields can be sorted in one of two ways by clicking the following icons: Initially only the basic fields are shown. To reveal all fields, click the Filter the list by entering all or part of a property name in the Filter box. |
Device Properties
This editor displays information about the device and basic configuration properties.
| Property | Description |
|---|---|
Device Name |
Used to identify the device. |
Location |
The physical location of the device. |
Description |
Other identifying information for the device. |
Box number |
Physical address used for identification by the Dynalite system. |
Serial number |
The serial number of the device. |
Device location sequence |
Identifies devices sequentially on a series network, not required. |
| Property | Description |
|---|---|
Start delay (rounded to 10 ms) |
Delay after start-up before sending sign-on message. Maximum value: 00:30:000 (rounded to 10 ms). |
| Property | Description |
|---|---|
Default to DyNet2 |
Sets the default messages from the device to DyNet2. Leave this option set to False unless advised by Philips Dynalite. |
Route RS-485 bad packets to trunk |
Enables the gateway to route bad packets received on the RS-232 network to the trunk port inside a valid DyNet2 message for analysis. Leave this option Disabled, unless advised by Philips Dynalite. |
Routing
The Routing editor configures routing-related settings and filters for routing messages between the two ports.
| No routing configuration changes are required for normal operation. |
Switches
The Switches editor defines actions for the gateway’s AUX input.
See Ethernet Gateways > Property Editors > Switches for more information.
Tasks
The Tasks editor enables you to create complex tasks from a range of templates, and manually code and edit your own custom tasks from scratch (See Tasks and Events).
For more information on custom task scripting, refer to the System Builder Training Guide or contact Dynalite support at support.controls@signify.com.