Registering your Cloud Gateway
To provide remote connectivity to a site, an on-site PDDEG-S must be registered as a cloud gateway in System Builder.
Before registering the gateway, you need to set the job and gateway location and time zone. These may not be the same.
-
For the job file, select Configure >
Location. -
For the gateway, right-click the device and select Configure >
Set Location and Time Zone.
| To register an online gateway, SB must be logged into a Dynalite account and the gateway must have internet access. |
The cloud gateway uses the MQTT protocol to establish a secure TCP connection to the cloud service using factory credentials. The cloud LED indicator on the front of the PDDEG-S flashes to show when it is trying to connect to the cloud. Once you assign it to a project and register the gateway, the LED permanently stays on. The PDDEG-S v2 (one Ethernet port) cloud LED is white and the PDDEG-S v3 (two Ethernet ports) cloud LED is green.
SB displays one of the following icons next to the registered cloud gateway:
-
Online gateway registered and job opened from the cloud. -
Online gateway registered and job opened from local network.
-
Open the job in System Builder.
-
Select the PDDEG-S that will be used as the cloud gateway.
-
Right-click the PDDEG-S and select Gateway Actions >
Register Cloud Gateway. The gateway identity details are shown.The MAC should be formatted as six sets of two hexadecimal characters, separated by colons. If the MAC Address field is blank:
-
Press Cancel.
-
Right-click the PDDEG-S and select
Request Device Information. -
Restart this procedure.
-
-
Click the button. SB registers the gateway in the DCP.
-
SB prompts you to create a new online job file.
-
Select your Organisation from the dropdown list and enter the Job File > Name and Description.
-
Click the button to upload the job to the cloud.