DALI luminaire management
The Manage luminaires tab is only visible in rooms and locations with DALI controllers. Unpaired luminaires are displayed on the left, and control channels are displayed with their Paired luminaires (if any) on the right.
| If the channel list in Paired luminaires appears doubled up, you can clear DALI pairing from the room’s DALI controller via the System Builder commissioning software. Refer to Commissioning > On-Site Configuration > DALI Pairing for more information. |
|
If a single paired DALI luminaire is offline and gets replaced, the system automatically pairs the new luminaire to the same channel. If multiple luminaires are offline, each replacement must be manually flashed/identified and paired as described below. |
To refresh the list of available luminaires, click 
Reload list on the left.
Flashing
To flash a luminaire on and off, click the 
lightbulb symbol.
This allows a person in the room to visually identify the luminaire so it can be paired to the correct channel.
The luminaire will stop flashing automatically after a brief time, or you can click the 
progress indicator to stop it manually.
Pairing
Click the Pair button next to a luminaire to open the Pair Luminaire dialog.
Use the search bar to filter the list of available channels if necessary, then select the correct channel. You can also click the lightbulb symbol in the bottom left corner to flash the luminaire for confirmation without leaving the dialog box. Click the Pair button to complete the process.
The paired luminaire is now shown next to its associated channel on the right. To remove a luminaire from a channel, click the Unpair button.
Deploying changes to the room
After creating the desired pairings for the room, click the Deploy to room button to open the Deployment dialog.
Click Deploy changes again to proceed.
Deployment may take several minutes, after which the Manage luminaires page automatically reloads. You can also manually refresh the page from your browser without interrupting the process.
|
|
DALI driver/ballast and lamp errors
Ballast failure, Lamp failure and Ballast offline errors are indicated by an 
error symbol.
Hover your cursor over the symbol to view the error type.
Offline DALI controllers and channel alerts are displayed along with those for all other devices and channels under the Alerts & Health tab.
